LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1040 (Rear Drive Axle) >> Repair Instructions >> Lubricant Replacement - Rear Drive Axle (8.6 Inch Axle) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new gasket and the rear axle housing cover (2).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Do not reuse the rear axle housing cover bolts.
  2. Install the new rear axle housing cover bolts (1).

    Tighten:  Tighten the bolts to 40 N.m (30 lb ft).

    3. Fig 1: Identifyng Rear Axle Housing Cover & Bolts
    GM341650Courtesy of GENERAL MOTORS CORP.
  3. Fill the rear axle. Use the proper fluid. Refer to Capacities - Approximate Fluid and Fluid and Lubricant Recommendations in Maintenance and Lubrication.
  4. Install the rear axle fill plug.

    Tighten:  Tighten the rear axle fill plug to 33 N.m (24 lb ft).

    5. Fig 2: View Of Rear Axle Fill Plug
    GM392774Courtesy of GENERAL MOTORS CORP.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals