Lubricant Level Inspection - Rear Drive Axle (11.5 Inch Axle)
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Make sure the vehicle is level.
- Inspect the rear axle for leaks. Repair as necessary.
- Clean the area around the rear axle fill plug.
- Remove the rear axle fill plug and the seal.
- Inspect the lubricant level.
Specification: The lubricant level should be between 17-21 mm (0.6-0.8 in) below the fill plug opening.
- If the level is low, add lubricant until the level is between 17-21 mm (0.6-0.8 in) below the fill plug opening. Use the proper fluid. Refer to Fluid and Lubricant Recommendations in Maintenance and Lubrication.
- Install the rear axle fill plug and gasket.
Tighten: Tighten the rear axle fill plug to 33 N.m (24 lb ft).
- Lower the vehicle.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.