LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1040 (Rear Drive Axle) >> Repair Instructions >> Differential Replacement (10.5 Inch, 11.5 Inch Axle) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the axle shafts. Refer to Rear Axle Shaft and/or Gasket Replacement .
  3. Remove the rear axle housing cover and the gasket. Refer to Rear Axle Housing Cover and Gasket Replacement .
  4. Remove the differential bearing adjuster nut retainers.
    5. Fig 1: Removing Differential Bearing Adjuster Nut Retainers
    GM667492Courtesy of GENERAL MOTORS CORP.
  5. Remove the bearing caps and bolts. Mark the bearing caps left and right.
    6. Fig 2: Removing/Installing Bearing Cap Bolt
    GM667502Courtesy of GENERAL MOTORS CORP.
    CAUTION: To prevent personal injury and/or component damage, support the differential case when removing the case from the axle housing. If the case is not supported, the differential case could fall and cause personal injury or damage to the differential case.
    NOTE: When removing the differential case from the axle housing, do not damage the cover gasket surface. If the cover gasket surface is damaged, lubricant may leak from the axle and cause premature failure of the axle assembly.
  6. Loosen the adjusters using the J 24429  .
  7. Remove the differential.
    8. Fig 3: View Of Differential Case And Axle Housing
    GM667660Courtesy of GENERAL MOTORS CORP.
  8. Remove the bearing cups.

    Mark the cups left and right. Place the cups with the bearing caps.

  9. Remove the differential side bearings, if necessary. Refer to Differential Side Bearings Replacement (All Except 9.75 Inch Axle)  or Differential Side Bearings Replacement (9.75 Inch Axle) .
  10. Remove the ring gear, if necessary. Refer to Drive Pinion and Ring Gear Replacement (8.6 Inch, 9.5 Inch, 11.5 Inch Axles) , Drive Pinion and Ring Gear Replacement (9.75 Inch Axle)  or Drive Pinion and Ring Gear Replacement (10.5 Inch Axle) .
scientia non olet · About LEMON Manuals