LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1037 (Disc Brake System) >> Repair Instructions >> Disc Brake Backing Plate Replacement - Rear (15 Series W/NYS) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  4. Relieve the tension from the park brake cable by pulling down on the intermediate cable then release the cable from the equalizer bar.
    5. Fig 1: Equalizer Bar & Park Brake Cable - Rear
    GM791349Courtesy of GENERAL MOTORS CORP.
  5. Remove the rear park brake bracket bolt.
    6. Fig 2: Identifying Rear Park Brake Bracket Bolt
    GM791353Courtesy of GENERAL MOTORS CORP.
  6. Remove the park brake cable from the park brake actuator lever.
    7. Fig 3: View Of Park Brake Cable To Park Brake Actuator Lever
    GM791352Courtesy of GENERAL MOTORS CORP.
  7. Remove the wheel bearing. Refer to Wheel Hub and Bearing Replacement in Rear Wheel Steering.
  8. Remove the park brake shoe.
  9. Remove the park brake actuator lever housing from the backing plate.
  10. Remove the backing plate.
scientia non olet · About LEMON Manuals