LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1037 (Disc Brake System) >> Repair Instructions >> Disc Brake Backing Plate Replacement - Rear (15 Series W/NYS) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the park brake actuator lever housing to the backing plate.
  2. Install the park brake shoe.
  3. Install the wheel bearing and adjust the park brake shoe. Refer to Wheel Hub and Bearing Replacement in Rear Wheel Steering and Park Brake Adjustment in Park Brake.
    4. Fig 1: View Of Park Brake Cable To Park Brake Actuator Lever
    GM791352Courtesy of GENERAL MOTORS CORP.
  4. Install the park brake cable to the park brake actuator lever.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the rear park brake bracket bolt.

    Tighten:  Tighten the bolt to 61 N.m (45 lb ft).

    6. Fig 2: Identifying Rear Park Brake Bracket Bolt
    GM791353Courtesy of GENERAL MOTORS CORP.
  6. Install the park brake cable to the equalizer bar.
    7. Fig 3: Equalizer Bar & Park Brake Cable - Rear
    GM791349Courtesy of GENERAL MOTORS CORP.
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals