LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1037 (Disc Brake System) >> Repair Instructions >> Brake Rotor Replacement - Rear (W/Dual Wheels) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the hub and the rotor (if applicable).
  2. Install each of the new wheel studs into the hub and rotor assembly by performing the following steps:
    1. Install the stud.
    2. Install 4 washers to the stud.
    3. Install a lug nut to the stud with the flat side of the nut towards the washers.
    4. Tighten the lug nut to draw the stud into the hub and rotor assembly.
    5. Inspect the hub and rotor assembly to ensure that the hub is tight against the rotor and the stud is seated completely.
    6. Remove the lug nut and the washers.
    3. Fig 1: View Of Wheel Studs, Hub & Rotor Assembly - Rear (W/Dual Wheels)
    GM360809Courtesy of GENERAL MOTORS CORP.
  3. Install the hub and rotor assembly to the vehicle. Refer to Rear Axle Hub, Bearing, Cup, and/or Seal Replacement in Rear Drive Axle.
  4. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Lower the vehicle.
  6. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance.
  7. Slowly release the brake pedal.
  8. Wait 15 seconds, then repeat steps 6-7 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
  9. Fill the master cylinder reservoir to the proper level with clean brake fluid. Refer to Master Cylinder Reservoir Filling in Hydraulic Brakes.
scientia non olet · About LEMON Manuals