Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the anti-rattle clips to the brake caliper mounting bracket.
Install the brake pads to the brake caliper mounting bracket.
Install the brake caliper to the brake caliper mounting bracket.
Install the brake caliper mounting bolts to the brake caliper mounting bracket. Do not tighten.

Fig 1: View Of Disc Brake Pads & Brake Caliper Mounting Bracket

Courtesy of GENERAL MOTORS CORP.

Install the brake caliper and brake caliper mounting bracket (1) as an assembly.
Perform the following procedure before installing the brake caliper mounting bracket bolts.
1. Remove all traces of the original adhesive patch.
2. Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
3. Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the brake caliper mounting bracket bolts (2).
Tighten: Tighten the brake caliper mounting bracket bolts to 300 N.m (221 lb ft).
Tighten the brake caliper mounting bolts (2).
Tighten: Tighten the brake caliper mounting bolts to 108 N.m (80 lb ft).

Fig 2: Brake Caliper Bracket Mounting & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Lower the vehicle.
With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance.
Slowly release the brake pedal.
Wait 15 seconds, then repeat steps 11-12 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.