LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1036 (Suspension Control System - Suspension Damping) >> Repair Instructions >> Electronic Suspension Ride Control Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel trim bezel. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster in Instrument Panel, Gages and Console.
    2. Fig 1: Removing Switch From The Lower Opening Of The Switch Plate Panel
    GM361792Courtesy of GENERAL MOTORS CORP.
  2. Remove the switch from the lower opening of the switch plate panel.
  3. Disconnect the electrical connector.
scientia non olet · About LEMON Manuals