Selectable Ride Indicator Inoperative
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Selectable Ride Indicator Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Suspension Controls Schematics Connector End View Reference: Suspension Controls Connector End Views |
|||
| 1 | Did you review the system circuit description and perform the necessary inspections? | Go to Step 2 | Go to Symptoms - Selectable Ride |
| 2 | Verify the fault is present. Does the system operate normally? |
Go to Testing for Electrical Intermittents in Wiring Systems | Go to Step 3 |
| 3 |
|
Go to Step 5 | Go to Step 4 |
| 4 | Connect a test lamp and back probe, between the ignition 1 voltage circuit and a good ground. Refer to Circuit Testing
in Wiring Systems. Does the test lamp illuminate? |
Go to Step 8 | Go to Step 6 |
| 5 |
|
Go to Step 6 | Go to Step 7 |
| 6 | Repair the open in the ignition 1 voltage circuit between the selectable ride switch and Body Wiring Harness Junction Block. Refer to Wiring Repairs
in Wiring Systems. Did you complete the repair? |
Go to Step 9 | - |
| 7 | Repair the open selectable ride switch indicator ground circuit. Refer to Wiring Repairs
in Wiring Systems. Did you complete the repair? |
Go to Step 9 | - |
| 8 | Replace the selectable ride switch. Refer to Electronic Suspension Ride Control Switch Replacement . Did you complete the replacement? |
Go to Step 9 | - |
| 9 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |