LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1034 (Automatic Transmission - 4L60-E/4L65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Flexplate Replacement (5.3L Engine w/RPO HP2) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission. Refer to Transmission Replacement (5.3L Engine w/RPO HP2) .
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the J 46093  (1) and bolts.

    The flange of the J 46093  should locate into the hole in the flexplate. Use two M10 1.5 x 40 mm bolts for proper tool operation.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    Fig 1: Installing J 46093 And Bolts
    GM1277133Courtesy of GENERAL MOTORS CORP.
    3. Fig 2: Removing The Flexplate
    GM1281915Courtesy of GENERAL MOTORS CORP.
  3. Remove the flexplate bolts.
  4. Remove the flexplate.
scientia non olet · About LEMON Manuals