LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1034 (Automatic Transmission - 4L60-E/4L65-E (Introduction, Service & Replacement)) >> Repair Instructions >> 2-4 Servo >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install NEW seals onto the servo pistons and the servo cover.
  2. Install the 2-4 servo.
    Fig 1: View Of 2-4 Servo
    GM642523Courtesy of GENERAL MOTORS CORP.
  3. Install the J 29714-A  .
    4. Fig 2: Compressing The Servo Cover Using J 29714-A
    GM14478Courtesy of GENERAL MOTORS CORP.
  4. Tighten the bolt onJ 29714-A  in order to compress the servo cover.
  5. Install the servo cover ring.
  6. Remove the J 29714-A  .
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the oil pan bolt.

    Tighten:  Tighten the bolt to 11 N.m (97 lb in).

    8. Fig 3: View Of Heat Shield/Exhaust Pipe Hanger Bracket & Bolts
    GM858548Courtesy of GENERAL MOTORS CORP.
  8. Install the heat shield and bolts.

    Tighten:  Tighten the bolts to 17 N.m (13 lb ft).

  9. Install the exhaust pipe. Refer to Exhaust Manifold Pipe Replacement (6.0L, 6.6L, and 8.1L Engines) in Engine Exhaust.
  10. Fill the transmission to the proper level with DEXRON® III transmission fluid. Refer to Transmission Fluid Checking Procedure .
scientia non olet · About LEMON Manuals