Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the retractor to the vehicle.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 1: Installing The Rear Seat Belt Retractor - Rear (Extended Cab)

Courtesy of GENERAL MOTORS CORP.

Install the rear seat belt retractor to body bolt (1).
Tighten: Tighten the bolt to 53 N.m (39 lb ft).
Install the rear quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter (Regular Cab) or Trim Panel Replacement - Rear Quarter (Extended Cab) or Trim Panel Replacement - Rear Quarter (Crew Cab) in Interior Trim.
Install the rear seat belt to body bolts (2).
Tighten: Tighten the bolts to 53 N.m (39 lb ft).

Fig 2: Seat Belt Assembly - Rear (Extended Cab)
Courtesy of GENERAL MOTORS CORP.

Fig 3: Installing The Rear Seat Belt To Body Bolts - Rear (Extended Cab)
Courtesy of GENERAL MOTORS CORP.
Install the seat belt guide cover (1).
Install the rear seat. Refer to Seat Replacement - Rear (Extended Cab w/4th Door) or Seat Replacement - Rear (Extended Cab) or Seat Replacement - Rear (60/40 Split) in Seats.