Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the retractor to the vehicle.
Install the rear seat belt retractor to body bolt (1).
Tighten: Tighten the bolt to 53 N.m (39 lb ft).

Fig 1: Installing The Rear Seat Belt Retractor To Body Bolt - Rear (Crew Cab)
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the rear seat belt to body bolts.
Tighten: Tighten the bolts to 53 N.m (39 lb ft).
Install the rear quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter (Regular Cab) or Trim Panel Replacement - Rear Quarter (Extended Cab) or Trim Panel Replacement - Rear Quarter (Crew Cab) in Interior Trim.
Install the rear seat, if removed. Refer to Seat Replacement - Rear (Extended Cab w/4th Door) or Seat Replacement - Rear (Extended Cab) or Seat Replacement - Rear (60/40 Split) in Seats.