Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the bolt (1) to the seat belt anchor.
Tighten: Tighten the bolt to 52 N.m (38 lb ft).

Fig 1: Installing The Bolt In Seat Belt Anchor - Center Rear
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 2: Installing The Nut To The Seat Belt Retractor - Center Rear

Courtesy of GENERAL MOTORS CORP.

Install the nut to the seat belt retractor.
Tighten: Tighten the nut to 52 N.m (38 lb ft).
Install the J-Clip under the center armrest.
Install the rear seat armrest. Refer toArmrest Replacement - Rear Seat (60/40 Split) in Seats.
Install the seat belt guide cover (1).

Fig 3: Installing The Seat Belt Guide Cover - Center Rear
Courtesy of GENERAL MOTORS CORP.