Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Position the buckle assembly to the floor panel stud.

Fig 1: Installing The Rear Seat Belt Buckle - Rear (Extended Cab)
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the rear seat belt buckle nuts.
Tighten: Tighten the nuts to 53 N.m (39 lb ft).
Fold the rear seat down.
Pull the seat belt buckles through the seat cushion.