LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1032 (Seat Belt System) >> Repair Instructions >> Seat Belt Buckle and Latch Replacement - Rear (Crew Cab) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the buckle assembly.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Rear Seat Cushion Cover, Frame & Foam Pad
    GM276675Courtesy of GENERAL MOTORS CORP.
  2. Install the bolt (13) that retains the buckle assembly (14) to the seat frame.

    Tighten:  Tighten the bolts to 53 N.m (39 lb ft).

  3. Install the rear seat cushion and cover. Refer to Seat Cushion Cover and Pad Replacement - Rear .
scientia non olet · About LEMON Manuals