LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1032 (Seat Belt System) >> Repair Instructions >> Seat Belt Buckle Replacement - Center Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the buckle assembly to the rear seat.
    Fig 1: Installing Seat Belt Buckle - Center Rear
    GM872059Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nut that retains the buckle assembly to the floor stud.

    Tighten:  Tighten the nut to 52 N.m (38 lb ft).

  3. Install the two bolts that retain the buckle assembly to the back of the seat frame.

    Tighten:  Tighten the bolts to 3 N.m (26 lb in).

  4. Fold the rear seat to the closed position.
scientia non olet · About LEMON Manuals