LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Engine Controls Self-Diagnostics - 2.2L) >> Diagnostic Tests >> DTC P0601-P0607, P1600, P1621, P1627, P1680, P1681 0R P1683: Pcm Memory >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2002 Pontiac Sunfire, 2002 Pontiac Grand Am, 2002 Oldsmobile Alero, and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform diagnostic system check - engine controls. See DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM. After performing diagnostic system check - engine controls, go to next step.
  2. Is DTC P0602 set? If yes, go to next step. If no, go to step  5.
  3. Program PCM. See POWERTRAIN CONTROL MODULE REPROGRAMMING  under PROGRAMMING. Does DTC P0602 reset? If yes, go to next step. If no, go to step  6.
  4. Ensure all tool connections are secure. Ensure programming equipment is operating correctly. Ensure correct software/calibration package is used. Attempt to program PCM. See POWERTRAIN CONTROL MODULE REPROGRAMMING  under PROGRAMMING. Does DTC P0602 reset? If yes, go to next step. If no, go to step  6.
  5. Replace PCM. See POWERTRAIN CONTROL MODULE in appropriate REMOVAL, OVERHAUL & INSTALLATION article. Perform PCM relearn procedure. See POWERTRAIN CONTROL MODULE REPROGRAMMING  under PROGRAMMING. After replacing PCM, go to next step.
  6. Using scan tool, clear DTCs. Turn ignition off for 30 seconds. Start engine. Operate vehicle. Does DTC run and pass? If yes, go to next step. If no, go to step  2.
  7. With a scan tool, observe the stored information, Capture Info. Does the scan tool display any DTCs that you have not diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.
scientia non olet · About LEMON Manuals