LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1028 (Transfer Case - NVG 261-NP2) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the J 43484  (2) to the J 8092  (1).
  2. Install the seal onto the J 43484  (2).
  3. Using the J 43484  (2) and the J 8092  (1), install the seal.
    4. Fig 1: Installing Transfer Case Output Shaft Seal Using J 8092 & J 43484
    GM678236Courtesy of GENERAL MOTORS CORP.
  4. Install the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
  5. Check the fluid level, add fluid if necessary.
  6. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
scientia non olet · About LEMON Manuals