LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1028 (Transfer Case - NVG 261-NP2) >> Repair Instructions >> Transfer Case Control Rod Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Before beginning the following service procedure, place a automatic transmission equipped vehicle into the PARK position, place a manual transmission equipped vehicle into FIRST GEAR. Then place the transfer case in the 2 HI position.
  1. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  2. Remove the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
    3. IMPORTANT: When performing this service procedure, use a small pocket screwdriver in order to release the retaining clip on the ends of the control rod.
  3. Remove the control rod from the control lever.
    4. Fig 1: Removing Transfer Case Control Rod From Control Lever
    GM649764Courtesy of GENERAL MOTORS CORP.
  4. Remove the control rod from the shift lever.
  5. Remove the control rod.
    6. Fig 2: Removing Transfer Case Control Rod
    GM396830Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals