LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1028 (Transfer Case - NVG 261-NP2) >> Repair Instructions >> Transfer Case Control Rod Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • Before installing a NEW control rod, loosen the adjusting bolt on the control rod so it slides with slight resistance.
  • When installing the control rod on the control levers, a snapping sound should be heard or felt upon installation.
  1. Install the control rod onto the control lever first.
    2. Fig 1: Installing Transfer Case Control Rod
    GM396830Courtesy of GENERAL MOTORS CORP.
  2. Slide the control rod forward.
  3. Install the control rod onto the shift control lever.
    4. Fig 2: Installing Transfer Case Control Rod Onto Shift Control Lever
    GM396831Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Tighten the control rod adjusting bolt.

    Tighten:  Tighten the bolt to 15 N.m (11 lb ft).

    5. Fig 3: Tightening Transfer Case Control Rod Adjusting Bolt
    GM649765Courtesy of GENERAL MOTORS CORP.
  5. Install the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
  6. Install the transfer case shield, if equipped. Refer toTransfer Case Shield Replacement .
scientia non olet · About LEMON Manuals