LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1028 (Transfer Case - NVG 261-NP2) >> Repair Instructions >> Transfer Case Control Lever Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the control lever assembly.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the control lever bolts.

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

    3. Fig 1: Installing Control Lever Assembly
    GM396835Courtesy of GENERAL MOTORS CORP.
  3. Install the control lever bezel.
  4. Install the control lever bezel screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  5. Install the control lever knob.
    6. Fig 2: Installing Control Lever Knob & Transfer Case Bezel
    GM396836Courtesy of GENERAL MOTORS CORP.
  6. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  7. Install the shift control rod. Refer to Transfer Case Control Rod Replacement .
  8. Install the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
  9. Install the transfer case shield, if equipped. Refer to Transfer Case Fluid Replacement .
scientia non olet · About LEMON Manuals