LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1023 (Engine Mechanical - 6.6L (Lb7) (Repair Instructions 1 Of 4)) >> Repair Instructions (On-Vehicle & Off Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Valve Lifter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply clean engine oil to the roller and outside of the valve lifter.
  2. Install the valve lifter.
  3. Install the valve lifter guides on the valve lifters.
  4. Install the valve lifter guide retainer.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    5. Fig 1: View Of Valve Lifter, Guides, Retainers & Bolts
    GM660517Courtesy of GENERAL MOTORS CORP.
  5. Tighten the valve lifter guide retainer bolt.

    Tighten:  Tighten the bolt to 11 N.m (97 lb in).

  6. Install the cylinder head. Refer to Cylinder Head Replacement - Left  or Cylinder Head Replacement - Right .
scientia non olet · About LEMON Manuals