LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1021 (Engine Mechanical - 8.1L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Left >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will result in a damaged oil pickup unit.
  1. If vehicle is a 2 wheel drive (2WD), raise the vehicle to a height to work through the front wheelhouse opening.
  2. If vehicle is a 4 wheel drive (4WD), raise the vehicle in order to remove the front tires and wheels.
  3. Remove the left front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  4. Remove the wheelhouse inner panel push pin retainers (2).
  5. Remove the wheelhouse inner panel (1).
    6. Fig 1: View Of Wheelhouse Panel & Push-In Retainers
    GM401885Courtesy of GENERAL MOTORS CORP.
  6. Working through the wheelhouse opening, remove the engine mount heat shield bolts.
  7. Remove the engine mount heat shield.
    8. Fig 2: View Of Engine Mount Heat Shield
    GM750194Courtesy of GENERAL MOTORS CORP.
  8. Remove the engine mount-to-engine mount bracket bolt.
    9. Fig 3: View Of Engine Mount-To-Engine Mount Bracket
    GM750192Courtesy of GENERAL MOTORS CORP.
  9. If equipped, remove the oil pan skid plate bolts and plate.
    10. Fig 4: Identifying Oil Pan Skid Plate
    GM309158Courtesy of GENERAL MOTORS CORP.
  10. Remove the engine shield bolts and shield.
    IMPORTANT: When raising the engine only raise it enough to separate the engine mount from the engine mount bracket.
    Fig 5: View Of Engine Shield & Bolts
    GM750454Courtesy of GENERAL MOTORS CORP.
  11. Raise the engine with a suitable jack in order to remove the engine mount and bracket.
  12. Remove the engine mount-to-engine bolts.
  13. Remove the engine mount.
    14. Fig 6: View Of Engine Mount & Bolts
    GM750187Courtesy of GENERAL MOTORS CORP.
  14. Remove the engine mount bracket through bolts.
  15. Remove the engine mount bracket.
    16. Fig 7: View Of Left Engine Mount Bracket
    GM750189Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals