LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1021 (Engine Mechanical - 8.1L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Pump Drive Installation

Oil Pump Drive Installation

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply grease to the oil pump drive gear for ease of assembly.
    2. NOTE: Ensure both components are aligned correctly or serious engine damage will occur.
  2. Line up the oil pump drive gear with the oil pump drive shaft.
  3. Install the oil pump drive, making sure that the oil pump drive is fully seated in the engine block.
    4. Fig 1: View Of Oil Pump Drive
    GM470910Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the oil pump drive bolt.

    Tighten:  Tighten the oil pump drive bolt to 25 N.m (18 lb ft).

scientia non olet · About LEMON Manuals