Clutch Pilot Bearing Removal
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Tools Required
J 43276 Clutch Pilot Bearing Remover
- Remove the clutch pilot bearing using the J 43276
.
- Install the J 43276-1 tool body into the clutch pilot bearing.
- Using a wrench secure the J 43276-1 tool body.
- Insert the J 43276-2 forcing screw into the J 43276-1 tool body.
- Rotate the J 43276-2 forcing screw clockwise into the J 43276-1 tool body until the clutch pilot bearing is completely removed from the crankshaft.
- Rotate the J 43276-2 forcing screw counterclockwise to remove the J 43276-2 forcing screw from the J 43276-1 tool body.
- Remove the J 43276-1 tool body from the clutch pilot bearing.
- Discard the clutch pilot bearing.
CAUTION:
Refer to Safety Glasses Caution in Cautions and Notices.
NOTE:
When using the J 43276 Clutch Pilot Bearing Remover, always secure the J 43276-1 Clutch Pilot Bearing Remover tool body using a wrench. Do not allow the J 43276-1 tool body to rotate. Failing to do so causes damage to the J 43276-1 tool body.