Removal Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Place a suitable container under the engine in order to drain the oil.
- Remove the oil drain plug.
- Drain the engine oil.
- Remove the oil pan skid plate bolts and plate, if equipped.
- If equipped with a 2-wheel drive (2WD) vehicle, remove the crossmember bolts and crossmember.
- If equipped with a 4-wheel drive (4WD) vehicle, remove the crossmember bolts and crossmember.
- Disconnect the oil level sensor electrical connector.
- Remove the lower oil pan bolts/nuts.IMPORTANT: DO NOT damage the sealing surfaces when separating the lower oil pan from the upper oil pan.
- Separate the lower oil pan from the upper oil pan using J 37228 .
- Remove the lower oil pan.
- If necessary, clean and inspect the lower oil pan. Refer to Oil Pan Cleaning and Inspection - Lower .