LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1020 (Engine Mechanical - 6.6L (LLY)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Oil Pressure Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left wheelhouse inner panel. Refer to Wheelhouse Panel Replacement in Body Front End.
    IMPORTANT: Clean the area around the sensor. Do not allow debris to enter the engine.
  2. Disconnect the oil pressure sensor electrical connector.
    3. Fig 1: View Of Oil Pressure Sensor Electrical Connector
    GM1335546Courtesy of GENERAL MOTORS CORP.
  3. Using J 41712  , remove the oil pressure sensor (1).
    4. Fig 2: View Of Oil Pressure Sensor
    GM1364822Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals