LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1020 (Engine Mechanical - 6.6L (LLY)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a 3/8-inch breaker bar into the tensioner opening and rotate the tensioner counterclockwise.
  2. Remove the belt from the tensioner.
  3. Slowly release the tension on the tensioner arm.
  4. Remove the drive belt from the drive pulleys, if equipped with a single generator.
    5. Fig 1: View Of Drive Belt Routing (Single Generator)
    GM1363113Courtesy of GENERAL MOTORS CORP.
  5. Remove the drive belt from the drive pulleys, if equipped with dual generators.
    6. Fig 2: View Of Drive Belt Routing (Dual Generator)
    GM1363115Courtesy of GENERAL MOTORS CORP.
  6. Inspect the drive belt for excessive cracking or any visible damage and replace if necessary.
scientia non olet · About LEMON Manuals