LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1020 (Engine Mechanical - 6.6L (LLY)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Rear Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the flywheel. Refer to Engine Flywheel Replacement (Automatic Transmission)  or Engine Flywheel Replacement (Manual Transmission) .
  2. Clean the area around the crankshaft rear oil seal.
  3. Install J 44641  to the crankshaft rear oil seal.
  4. Remove the crankshaft rear oil seal using J 44641  .
    5. Fig 1: Removing Crankshaft Rear Oil Seal Using J 44641
    GM660312Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals