LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1020 (Engine Mechanical - 6.6L (LLY)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Charged Air Cooler Hoses/Pipes Replacement (Left) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left wheelhouse panel. Refer to Wheelhouse Panel Replacement in Body Front End.
    IMPORTANT: After removing the charged air cooler duct, cover the turbocharger opening with tape in order to prevent entry of objects.
  2. Loosen the left charged air cooler inlet duct connector to turbocharger clamp (1).
    3. IMPORTANT: Do not use a screwdriver or other tool to pry the hose loose. The hose can be torn or damaged. Loosen the hose by twisting.
  3. Remove the left charged air cooler inlet duct connector (4) from the turbocharger.
    4. Fig 1: View Of Turbocharger Clamp & Charged Air Cooler Inlet Duct Connector
    GM1334380Courtesy of GENERAL MOTORS CORP.
  4. Working through the left wheelhouse, loosen the charged air cooler inlet duct clamp (3) at the charged air cooler.
  5. Remove the left charged air cooler inlet duct.
    6. Fig 2: View Of Charged Air Cooler Inlet Duct & Clamps
    GM877283Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals