LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1020 (Engine Mechanical - 6.6L (LLY)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Pan Installation - Upper

Oil Pan Installation - Upper

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a 2-3 mm wide by 0.5-1.5 mm bead of P/N 97720043 sealant to the upper oil pan mating surfaces.
    2. Fig 1: Determining Sealant Bead Dimensions
    GM663817Courtesy of GENERAL MOTORS CORP.
  2. Install the upper oil pan to the engine block.
    3. Fig 2: View Of Upper Oil Pan
    GM1334851Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the upper oil pan bolts.

    Tighten:  Tighten the upper oil pan bolts in sequence to 20 N.m (15 lb ft).

    4. Fig 3: Upper Oil Pan Bolt Tightening Sequence
    GM663823Courtesy of GENERAL MOTORS CORP.
  4. Install the two flywheel housing to upper oil pan bolts.

    Tighten:  Tighten the two flywheel housing to upper oil pan bolts to 50 N.m (37 lb ft)

    5. Fig 4: View Of Flywheel Housing To Upper Oil Pan Bolts
    GM1334849Courtesy of GENERAL MOTORS CORP.
  5. Install the oil level indicator tube.
  6. Install the oil level indicator tube bracket bolt.

    Tighten:  Tighten the oil level indicator tube bracket bolt to 21 N.m (15 lb ft).

    7. Fig 5: View Of Oil Level Indicator
    GM1334847Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals