Exhaust Manifold Installation - Right

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the exhaust manifold gasket.
Install the exhaust manifold.

Fig 1: View Of Right Exhaust Manifold & Gasket

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the exhaust manifold bolts and nuts.
Tighten: Tighten the exhaust manifold bolts and nuts to 38 N.m (28 lb ft) in the proper sequence.

Fig 2: Exhaust Manifold Bolts & Nuts Installation Sequence (Left Side Shown; Right Side Similar)

Courtesy of GENERAL MOTORS CORP.

Install the exhaust manifold heat shield.
Install the exhaust manifold heat shield bolts.
Tighten: Tighten the exhaust manifold heat shield bolts to 10 N.m (89 lb in).

Fig 3: View Of Exhaust Manifold Heat Shield (Right)

Courtesy of GENERAL MOTORS CORP.