LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1020 (Engine Mechanical - 6.6L (LLY)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Drive Belt Tensioner and Generator Mounting Bracket Installation

Drive Belt Tensioner and Generator Mounting Bracket Installation

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the drive belt tensioner and generator mounting bracket.
    2. Fig 1: View Of Generator Mounting Bracket
    GM1334912Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the drive belt tensioner and generator mounting bracket bolts.

    Tighten:  Tighten the drive belt tensioner and generator mounting bracket bolts to 50 N.m (37 lb ft).

  3. Install the drive belt tensioner.
    4. Fig 2: View Of Drive Belt Tensioner
    GM1334909Courtesy of GENERAL MOTORS CORP.
  4. Install the drive belt tensioner bolt.

    Tighten:  Tighten the drive belt tensioner bolt to 50 N.m (37 lb ft).

  5. Install the electrical harness clip bolts.

    Tighten:  Tighten the electrical harness clip bolts to 10 N.m (89 lb in).

    6. Fig 3: Electrical Harness Clip Bolts
    GM1334907Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals