LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1019 (Engine Mechanical - 4.8L, 5.3L & 6.0L (Repair Instructions - 1 Of 3)) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Engine Valley Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold. Refer to Intake Manifold Replacement .
  2. Gently pry up the rubber covers.
    3. Fig 1: View Of Rubber Covers
    GM832149Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the knock sensor electrical connectors.
  4. Remove the knock sensors.
    5. Fig 2: View Of Knock Sensors
    GM309864Courtesy of GENERAL MOTORS CORP.
  5. Remove the engine valley cover bolts.
  6. Remove the engine valley cover and gasket.
    7. Fig 3: View Of Engine Valley Cover, Gasket & Bolts
    GM65048Courtesy of GENERAL MOTORS CORP.
  7. Discard the old gasket.
  8. Remove the knock sensor oil seals (1) from the cover (2).
    9. Fig 4: View Of Knock Sensor Oil Seals & Cover
    GM490851Courtesy of GENERAL MOTORS CORP.
  9. If required, clean and inspect the engine valley cover. Refer to Engine Valley Cover Cleaning and Inspection .
scientia non olet · About LEMON Manuals