LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1019 (Engine Mechanical - 4.8L, 5.3L & 6.0L (Repair Instructions - 1 Of 3)) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Engine Sight Shield Replacement (4.8L, 5.3L, and 6.0L Engines) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the sight shield retainer and the bolts, if required.

    Tighten:  Tighten the bolts to 5 N.m (44 lb in).

    2. Fig 1: View Of Sight Shield Retainer (4.8L, 5.3L & 6.0L)
    GM832095Courtesy of GENERAL MOTORS CORP.
    NOTE: Use care when installing the engine sight shield to avoid contacting the manifold absolute pressure (MAP) sensor wire harness connector. Loss of engine performance or engine damage may result.
  2. Install the intake manifold sight shield to the retainer.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: View Of Sight Shield (4.8L, 5.3L & 6.0L)
    GM832094Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals