LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1019 (Engine Mechanical - 4.8L, 5.3L & 6.0L (Repair Instructions - 1 Of 3)) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Right >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the wheelhouse panel. Refer to Wheelhouse Panel Replacement in Body Front End.
  4. Remove the exhaust manifold. Refer to Exhaust Manifold Replacement - Right (4.8L, 5.3L, and 6.0L Engines) in Engine Exhaust.
  5. Remove the engine protection shield. Refer to Engine Protection Shield Replacement in Frame and Underbody.
  6. Remove the engine mount heat shield, if equipped.
    7. Fig 1: View Of Engine Mount Heat Shield
    GM1235951Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: DO NOT raise and/or support the engine by the crankshaft balancer, or oil pan.
  7. Raise and support the engine using an adjustable (screw type) jack stand.
  8. Remove the engine mount-to-engine mount bracket bolts.
    9. Fig 2: View Of Engine Mount-To-Engine Mount Bracket
    GM307275Courtesy of GENERAL MOTORS CORP.
  9. Remove the engine mount bolts.
  10. Remove the right engine mount.
    11. Fig 3: View Of Right Engine Mount
    GM307279Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals