LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1019 (Engine Mechanical - 4.8L, 5.3L & 6.0L (Repair Instructions - 1 Of 3)) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the right engine mount to the engine.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the engine mount bolts to the engine.

    Tighten:  Tighten the engine mount bolts to 50 N.m (37 lb ft).

    3. Fig 1: View Of Right Engine Mount
    GM307279Courtesy of GENERAL MOTORS CORP.
  3. Install the engine mount-to-engine mount bracket bolts.
    4. Fig 2: View Of Engine Mount-To-Engine Mount Bracket
    GM307275Courtesy of GENERAL MOTORS CORP.
  4. Lower the engine.
  5. Remove the adjustable jack stands.
  6. Install the engine mount heat shield, if equipped.

    Tighten:  Tighten the engine mount-to-engine mount bracket bolts to 65 N.m (48 lb ft).

    7. Fig 3: View Of Engine Mount Heat Shield
    GM1235951Courtesy of GENERAL MOTORS CORP.
  7. Install the exhaust manifold. Refer to Exhaust Manifold Replacement - Right (4.8L, 5.3L, and 6.0L Engines) in Engine Exhaust.
  8. Install the wheelhouse panel. Refer to Wheelhouse Panel Replacement in Body Front End.
  9. Install the engine protection shield. Refer to Engine Protection Shield Replacement in Frame and Underbody.
  10. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals