LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1019 (Engine Mechanical - 4.8L, 5.3L & 6.0L (Repair Instructions - 1 Of 3)) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Left >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will result in a damaged oil pickup unit.
  1. Remove the engine mount heat shield, if equipped.
    2. Fig 1: View Of Engine Mount Heat Shield
    GM1235951Courtesy of GENERAL MOTORS CORP.
  2. Remove the engine mount-to-engine mount bracket bolts. (Right side shown, left side similar).
    3. Fig 2: View Of Engine Mount-To-Engine Mount Bracket
    GM307275Courtesy of GENERAL MOTORS CORP.
  3. If vehicle is a 2 wheel drive (2WD), raise the vehicle to a height to work through the front wheelhouse opening.
  4. If vehicle is a 4 wheel drive (4WD), raise the vehicle in order to remove the front tires and wheels.
  5. Remove the left front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Remove the wheelhouse inner panel push pin retainers (2).
  7. Remove the wheelhouse inner panel (1).
    8. Fig 3: View Of Wheelhouse Panel & Push-In Retainers
    GM401885Courtesy of GENERAL MOTORS CORP.
  8. Remove the engine shield bolts.
  9. Remove the engine shield.
    IMPORTANT: DO NOT raise and/or support the engine by the crankshaft balancer, or oil pan.
    10. Fig 4: View Of Engine Protection Shield
    GM349061Courtesy of GENERAL MOTORS CORP.
  10. Raise and suitably support the engine using adjustable (screw type) jack stands.
  11. Remove the engine mount bolts.
  12. For vehicles with 4WD, remove the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
  13. Remove the left engine mount.
    14. Fig 5: View Of Left Engine Mount
    GM679415Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals