LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1019 (Engine Mechanical - 4.8L, 5.3L & 6.0L (Repair Instructions - 1 Of 3)) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the left engine mount to the engine.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the engine mount bolts.

    Tighten:  Tighten the engine mount bolts to 50 N.m (37 lb ft).

    3. Fig 1: View Of Left Engine Mount
    GM679415Courtesy of GENERAL MOTORS CORP.
  3. Lower the engine.
  4. Remove the adjustable jack stands.
  5. Install the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
  6. Position the engine shield to the vehicle.
  7. Install the engine shield bolts.

    Tighten:  Tighten the engine shield bolts to 20 N.m (15 lb ft).

    8. Fig 2: View Of Engine Protection Shield
    GM349061Courtesy of GENERAL MOTORS CORP.
  8. Lower the vehicle.
  9. Install the engine mount-to-engine mount bracket bolts. (Right side shown, left side similar).
    10. Fig 3: View Of Engine Mount-To-Engine Mount Bracket
    GM307275Courtesy of GENERAL MOTORS CORP.
  10. Install the engine mount heat shield, if equipped.

    Tighten:  Tighten the engine mount-to-engine mount bracket bolts to 65 N.m(48 lb ft).

    11. Fig 4: View Of Engine Mount Heat Shield
    GM1235951Courtesy of GENERAL MOTORS CORP.
  11. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  12. Install the wheelhouse inner panel push pin retainers (2).
  13. Install the wheelhouse inner panel (1).
    14. Fig 5: View Of Wheelhouse Panel & Push-In Retainers
    GM401885Courtesy of GENERAL MOTORS CORP.
  14. Lower the vehicle.
scientia non olet · About LEMON Manuals