LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1019 (Engine Mechanical - 4.8L, 5.3L & 6.0L (Repair Instructions - 1 Of 3)) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Engine Mount Bracket Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine mount bracket.
  2. Perform the following procedure prior to installing the engine mount bracket bolts.
    • Remove all traces of the original adhesive patch.
    • Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
    • Apply threadlocker GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the bolts.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the engine mount bracket bolts.

    Tighten:  Tighten the engine mount bracket bolts to 75 N.m (55 lb ft).

    4. Fig 1: View Of Left Engine Mount Bracket
    GM678843Courtesy of GENERAL MOTORS CORP.
  4. Install the engine mount. Refer to Engine Mount Replacement - Left .
scientia non olet · About LEMON Manuals