LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1019 (Engine Mechanical - 4.8L, 5.3L & 6.0L (Repair Instructions - 1 Of 3)) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Drive Belt Replacement - Air Conditioning >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the A/C belt around the crankshaft balancer.
  2. Install a ratchet into the A/C drive belt tensioner adapter opening
  3. Rotate the A/C belt tensioner clockwise in order to relieve tension on the tensioner.
  4. Install the A/C belt over the idler pulley.
    5. Fig 1: A/C Belt Tensioner
    GM370869Courtesy of GENERAL MOTORS CORP.
  5. Install the A/C belt around the A/C compressor pulley.
  6. Slowly release the tension on the A/C belt tensioner.
  7. Remove the ratchet from the A/C belt tensioner.
  8. Inspect the A/C belt for proper installation and alignment.
  9. Install the engine shield.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  10. Install the engine shield bolts.

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

    11. Fig 2: View Of Engine Protection Shield
    GM349061Courtesy of GENERAL MOTORS CORP.
  11. Lower the vehicle.
  12. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory (4.8L, 5.3L, and 6.0L Engines)  or Drive Belt Replacement - Accessory (5.3L Engine w/RPO HP2) .
scientia non olet · About LEMON Manuals