LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1018 (Engine Mechanical - 4.3L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Valve Lifter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: It is normal for NEW lifters to make a slight ticking noise when the engine is first started. Increasing the engine RPMs slightly to raise oil pressure should stop the noise.
  1. Apply lubricant GM P/N 12345501, (Canadian P/N 992704), or equivalent to the lifter rollers.
    2. IMPORTANT: If reusing the lifters, install the lifters to their original positions.
  2. Install the lifters.
    3. Fig 1: View Of Valve Lifters
    GM328593Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the lifter pushrod guides.

    Tighten:  Tighten the bolts to 16 N.m (12 lb ft).

    4. Fig 2: View Of Valve Lifter Pushrod Guides
    GM328592Courtesy of GENERAL MOTORS CORP.
  4. Install the pushrods. Refer to Valve Rocker Arm and Push Rod Replacement .
  5. Install the intake manifold. Refer to Intake Manifold Replacement - Lower .
scientia non olet · About LEMON Manuals