LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1018 (Engine Mechanical - 4.3L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Left >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to Engine Mounting Notice in Cautions and Notices.
  1. From under the hood, remove the engine mount to engine mount bracket bolts. (right side shown, left side similar).
    2. Fig 1: Removing Engine Mount To Engine Mount Bracket & Bolts
    GM310259Courtesy of GENERAL MOTORS CORP.
  2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the oil pan skid plate bolts and plate.
    4. Fig 2: Identifying Oil Pan Skid Plate
    GM309158Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Engine Lifting Notice in Cautions and Notices.
  4. Using an adjustable jack on the square tab at the rear of the engine block, raise the engine.
    5. Fig 3: View Of Square Tab At Rear Of Engine Block
    GM374320Courtesy of GENERAL MOTORS CORP.
  5. Remove the engine mount bolts. (right side shown, left side similar).
    6. Fig 4: Removing Engine Mount Bolts
    GM310267Courtesy of GENERAL MOTORS CORP.
  6. Remove the engine mount.
  7. If equipped and necessary, remove the engine mount side bracket bolts and bracket. (right side shown, left side similar).
    8. Fig 5: Removing Engine Mount Side Bracket & Bolts
    GM310262Courtesy of GENERAL MOTORS CORP.
  8. Remove the engine mount bracket bolts.
  9. Remove the engine mount bracket.
    10. Fig 6: Removing Engine Mount Bracket & Bolts
    GM781984Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals