LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1018 (Engine Mechanical - 4.3L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Tensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the belt tensioner. Position the locating pin (1) on the tensioner into the hole in the generator bracket.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    2. Fig 1: Drive Belt Tensioner Locating Pin
    GM869705Courtesy of GENERAL MOTORS CORP.
  2. Install the belt tensioner bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  3. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals