LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1018 (Engine Mechanical - 4.3L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Balance Shaft Bearing and/or Bushing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The balance shaft and the front bearing are serviced only as a package. Do not remove the bearing from the balance shaft.
  1. Remove the balance shaft. Refer to Balance Shaft Replacement .
  2. Using J 26941 and the J 38834  , remove the balance shaft rear bearing.
    1. Install the J 26941 legs behind the balance shaft rear bearing and secure.
    2. Install the J 38834-1 with the short threaded end through the balance shaft bore in the front of the engine block.
    3. Install J 38834-1 into the J 26941.
    4. Slide the J 38834-2 onto the J 38834-1 and into the balance shaft bore of the engine block.
    5. Install the J 38834  bearing, washer, and nut onto the J 38834-1.
    6. Using a wrench, secure the J 38834-1, and then rotate the J 38834  nut clockwise until the balance shaft rear bearing is removed from the engine block.
    7. Remove the J 26941 from the balance shaft rear bearing.
    3. Fig 1: Removing Balance Shaft Rear Bearing
    GM340081Courtesy of GENERAL MOTORS CORP.
  3. Discard the balance shaft rear bearing.
scientia non olet · About LEMON Manuals