Engine Flywheel Installation

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: If replacing the engine flywheel, manual transmission, note the position and length of the original flywheel weights, if applicable. Flywheel weights of the same length must be installed into the new engine flywheel in the same location as the old flywheel weights were in the old engine flywheel.

Note the position of the flywheel weights and install the NEW flywheel weights as required.
A properly installed flywheel weight will be flush or slightly below flush with the face of the engine flywheel.

Fig 1: Locating Flywheel Weights (Manual Transmission)

Courtesy of GENERAL MOTORS CORP.

Install the engine flywheel (1 or 2) to the crankshaft.
Align the engine flywheel locator hole to the flywheel locator pin.

Fig 2: Installing Engine Flywheels

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the engine flywheel bolts.
Tighten: Tighten the engine flywheel bolts in sequence to 100 N.m (74 lb ft).

Fig 3: Identifying Flywheel Bolt Tightening Sequence

Courtesy of GENERAL MOTORS CORP.