Cylinder Head Removal - Left

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine coolant temperature sensor, if applicable.

Fig 1: View Of Engine Coolant Temperature Sensor

GM387769

Courtesy of GENERAL MOTORS CORP.

Remove the engine coolant temperature gage sensor, if applicable.

Fig 2: Removing Engine Coolant Temperature Gage Sensor

GM387767

Courtesy of GENERAL MOTORS CORP.

Remove the spark plugs.

Fig 3: Removing Spark Plugs (Left)

GM328582

Courtesy of GENERAL MOTORS CORP.

Remove the bolts and the spark plug wire support.

Fig 4: Removing Bolts & Spark Plug Wire Support (Left)

GM328588

Courtesy of GENERAL MOTORS CORP.

Remove the cylinder head bolts and discard.

Fig 5: Locating Cylinder Head Bolts (Left)

GM480533

Courtesy of GENERAL MOTORS CORP.

NOTE: After removal, place the cylinder head on two wood blocks to prevent damage to the sealing surfaces.

Remove the cylinder head.

Fig 6: Removing/Installing Cylinder Head (Left)

GM480536

Courtesy of GENERAL MOTORS CORP.

Remove and discard the cylinder head gasket.

Fig 7: View Of Cylinder Head Gasket And Alignment Pins - Left

GM334299

Courtesy of GENERAL MOTORS CORP.

Remove the cylinder head locator dowel pins, if required.

Fig 8: Removing Cylinder Head Locator Dowel Pins (Left)

GM330548

Courtesy of GENERAL MOTORS CORP.