Conditions for Clearing the DTC
WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- A current DTC Last Test Failed clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
- Clear the DTC with a scan tool.
DTC P1112
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Engine Controls Schematics Connector End View Reference: Engine Controls Connector End Views or Powertrain Control Module (PCM) Connector End Views |
||||
| 1 | Did you perform the Diagnostic System Check-Engine Controls? | - | Go to Step 2 | Go to Diagnostic System Check - Engine Controls |
| 2 | Observe the DTC information with a scan tool. Is DTC P0112 set? |
- | Go to DTC P0112 | Go to Step 3 |
| 3 | Test for an intermittent and for a poor connection at the intake air temperature (IAT) sensor. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 5 | Go to Step 4 |
| 4 | Test the IAT signal circuit between the IAT sensor and the powertrain control module (PCM) for an intermittent short to ground. Refer to Inducing Intermittent Fault Conditions
and Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 5 | Go to Intermittent Conditions |
| 5 |
|
- | Go to Step 2 | Go to Step 6 |
| 6 | Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? |
- | Go to Diagnostic Trouble Code (DTC) List | System OK |