LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1014 (Hydraulic Brake System) >> Repair Instructions >> Brake Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Brake pipes that run parallel to each other must maintain a 6 mm (1/4 in) clearance.
  1. Disconnect the brake pipe fittings.
  2. Remove the brake pipe fasteners from the vehicle.
  3. Remove the brake pipe from the vehicle.
    4. Fig 1: Removing Brake Pipe
    GM161526Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals